PORSCHE 993 SEALSCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 1974-77 - Transmission (includes uncategorized and accessory items)
$7.60
Make a selection
$26.40
Make a selection 99911318540 Known as: shaft sealing ring b 15x24x7 / shaft sealing ring / shaft sealing ring a 15x24x7 / shaft sealing ring shaft sealing ring a 15 x 24 x 7 / shaft sealing ring 15 x 24 x 7 View/Change Diagram
From $9.50
Make a selection FVD7213365
$79.20
Make a selection 95510756100EQ
$24.20
Make a selection FVD7213364
$149.60
Make a selection 99970417250EQ Used as an oil pump seal or oil cooler seal, this is the smaller ring of the two that are used. Sold individually. 2 necessary per car.
$3.30
Make a selection 99911342641EQ High-quality OEM (original equipment manufacturer) replacement, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. Sold individually. 1 necessary per car.
$30.80
Make a selection FVD721T251 This special service tool was developed for the proper installation of oil seal on pulley side of crank shaft. Trying to do this task with any other method is risking a total engine failure by way of a damaged oil seal. Applicable: Porsche model - 996 & Boxster.
$129.80
Make a selection GR1019 If you are doing sheet metal repair to your Porsche (or any car, for that matter), wurth seam sealer is a must-have. It is used to seals seams & joints that are spot welded, riveted, or bolted. permanent adhesion to bare or painted surfaces. Brush able, low odor formula goes on thick to seal completely, and provides an OEM appearance when finished. Will not sag, shrink, or crack, and is paint-ready in 45 minutes. Temperature range from -13ºf to +176ºf. General FitmentACCESSORY
$58.50
Make a selection FVD911503185186 This seal kit consists of original part # 911 503 185 00 (left) and 911 503 186 00 (right). The set can be used on the trailing edge of the front fender at the cowl just below the windshield. It is also used under the back of the rear quarter panel where it meets the bumper side panel. Genuine part sourced from Porsche ag in Germany to ensure quality, reliability and precise fitment. Sold as a set. 1 set is necessary for front fenders and one set is necessary for the rear. Please note: this is the thinner width. This is not the thicker width from the SC models.
$14.93
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |